YG4032S Spray Gun

The General Pump YG4032S Industrial Spray Gun features tough brass and stainless steel inner parts inside an ergonomic shockproof plastic housing. It has an ample flow rate capacity of 32 GPM and is rated for discharge pressure up to 4,050 PSI. It has a rear entry inlet and the discharge port is oriented so the wand (not included) extends straight from the gun.

Specifications

• Maximum Volume: 32 GPM
• Rated Discharge Pressure: 4,050 PSI
• Maximum Discharge Pressure: 4,500 PSI
• Maximum Fluid Temperature: 210° Fahrenheit
• Inlet Port: 1/2" NPT-F
• Discharge Port: 1/2" NPT-F
• Weight: 2.8 lbs
• Dimensions: 10.08" x 6.68" x 1.2"
• Materials: Stainless steel, brass, plastic, Viton

Features

• Shockproof plastic housing
• Ergonomic design
• Internal construction of brass and stainless steel
• Minimizes fatigue for the operator

Safety Instructions and Recommendations

• This product is to be used with clean, fresh water. For use involving different or corrosive liquids, contact your GP’s  customer service department. Appropriate filtration should be installed when using unclean liquids. Choose the gun that most closely matches the rated pressure, max flow and max temperature of the pressure wash system. In any case, the pressure of the machine should not exceed the permissible pressure rate imprinted on the gun.
• This gun is designed to operate with hot water (in compliance with the technical specs), making sure not to exceed the max temperature. Always fit a safety valve to protect the system when the latter is under pressure. Choose a  suitable nozzle and adjust the valve mounted in the front of the gun, thus obtaining a constant supply and avoiding unwanted pressure spikes. If the nozzle wears out, the pressure falls. When you install a new nozzle, adjust the system back to the original pressure.
• The gun opens and closes a high pressure conduct by means of a piston acting on a seat; the return is controlled by a spring which releases the trigger. Attention: during pump activation ALWAYS set the gun with its safety latch connected in order to prevent accidental openings.
• WARNING: High Pressure Systems require a primary pressure regulating device (i.e. regulator, unloader) and a secondary pressure relief device (i.e. pop-off valve, relief valve). Failure to install such relief devices properly could result in personal injury or damage to pump or property. GP does not assume any liability or responsibility for the operation of the user’s high pressure system.

WARNING: This product can expose you to chemicals including Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm (For more information go to www.p65warnings.ca.gov).